DWX - 300/500
DATA STORAGE DRIVE
For MFM Disk Drives Remplacement
Our Emulators works with all formats and on all systems
With the introduction of a new drive/controller to replace ST506/412 MFM interface type disk drives, a new remplacement sources is now being offered for Seagate, Maxtor, Micropolis and other MFM type disk drives.
The new Datastorage DWX 500 drive replaces :
SEAGATE : ST225, ST238, ST251,ST 4038,ST 4096 etc...
MAXTOR : XT1085, XT1140, XT etc...
MICROPOLIS : 1325, 1355, etc ...
HONEYWELL BULL : D530, D550,D 570, etc ...
PRIAM/VERTEX : V170, V530, V570, V585 etc ...
Most of above disk drives are 51/4 inches full height products.
High data reliability :
Datastorage Drive use SCSI interface technology. Error correction is resolved on-the-fly inside the drive. MFM Type Interface drives, based on older technology, report data errors to the controller, which signals drive failure after exceeding the preset error limits.
Lower power and heat :
Three and one-half inch SCSI disk drives used by DATASTORAGE require only half the operating power needed by Maxtor drives. The lower power causes less heat which extends system component life to improve total system reliability.
Easy installation :
DATASTORAGE remplacement Drives are Prom based and programmed to match your drive before being Shipped.
Increased warranty :
DATASTORAGE provides a full one year factory remplacement warranty, FOB Paris, France. This compares to a three month typical drive repaired warranty.
P.A de Villejust – 9, place Marcel REBUFFAT – F-91971 COURTABOEUF 7 CEDEX FRANCE
tél. +33 (0)1 69 31 01 01 – fax. +33 (0)1 69 31 01 10 – e-mail: welcome@datexdsm.comr – site web: www.datexdsm.com
S.A.S. Au capital de 160.000€ - R.C.S EVRY 331 142 018 – SIRET 331 142 018 00026 – NAF 725Z – Int.TVA n°FR 81 331 142 018